|
) CD-ROM DRIVE MASTER\SLAVE CONFIGURATION
|
bet | 5/14 | Sana | 21.03.2017 | Hajmi | 52 Kb. | | #867 |
3) CD-ROM DRIVE MASTER\SLAVE CONFIGURATION
Make sure the CD-ROM drive is properly configured for Master or Slave. Please reference the CD-ROM drive's installation guide for the proper configuration instructions.
You have the following options.
A) If you find it necessary to connect the desktop CD-ROM drive in daisy-chain with your hard disk drive, configure the CD-ROM drive as SLAVE. Please note that some hard disk drives may have different configuration setting for a Single as compared to a Master in a dual-drive configuration. Therefore, in some cases when you daisy-chain the CD-ROM drive to your hard disk drive, it may also be necessary to change the hard disk drive’s configuration from a single to a Master drive configuration.
NOTE: There are some hard disk drive (HDD) manufacturers that do not allow a CD-ROM drive to be connected as Slaves to their units. Please reference your HDD documentation if necessary.
B) If you have the CD-ROM drive connected by itself on any of the available IDE ports, the drive has to be configured as MASTER.
|
| |