• 4.2.1 Installing the Paper
  • 4.2.2 Powering the Weather Station
  • Acknowledgements




    Download 3.42 Mb.
    bet3/9
    Sana02.01.2020
    Hajmi3.42 Mb.
    #8209
    1   2   3   4   5   6   7   8   9






    Figure 3 - Weather Station Top View



    4.2 Getting Started


    The following steps detail the process required to set up the device to be ready for printing.

    4.2.1 Installing the Paper


    1. Flip latch located on top of Weather Station to open the paper compartment.

    2. Place the paper roll into the compartment as shown in Figure 3.

    3. Firmly close the lid until it clicks. At least 1 cm of paper should extrude outside of the closed printer. This ensures the paper will not feed back into the compartment and jam the printer.








    4.2.2 Powering the Weather Station


    1. Place the Weather Station on a flat, sturdy surface near an outlet. Orient the unit printer-side up.

    2. Connect AC adaptor barrel plug into the back of the Weather Station.

    3. Plug AC adaptor into standard 120V AC wall socket.

    CAUTION: THIS PRODUCT IS MEANT FOR INDOOR USE ONLY. KEEP AWAY FROM AREAS OF EXTREME HEAT AND COLD. DO NOT PLACE NEAR SOURCES OF WATER.




    Download 3.42 Mb.
    1   2   3   4   5   6   7   8   9




    Download 3.42 Mb.