|
Changes from version 1.12.beta5 to 1.12.0
|
| bet | 7/11 | | Sana | 30.03.2021 | | Hajmi | 0.74 Mb. | | #13742 |
Changes from version 1.12.beta5 to 1.12.0
Added support for unique Garz & Fricke touch configuration files (.xml) which will be used by all devices with windows ce and linux operating systems.
Supporting four several touch interfaces:
NXP UCB 1400 AC97 Touch (resistive)
Pinnacle I2C Touch (capacitive)
EETI USB Touch (capacitive)
EDT Touch (capacitive)
BugFix: If the “Discovery Service” was disabled via RedBoot configuration it was still active on runtime. Now it disables correctly.
BugFix: Changed the display power on sequence. This fixed a bug where sometimes the display shows its content mirror inverted.
BugFix: Fixed SD-Card pin-configuration to prevent system hangs on some systems when inserting an SD-Card.
BugFix: While connecting the device via USB OTG to a PC a wrong device name was shown. No it shows “Cupid” as expected.
Adapted the freescales hardware acceleration configuration since for several cases (e.g. vertical lines of width 2 or more) it slew down the drawing performance massively.
Added a configurable pressure and median filter for the resistive touch (UCB1400) to remove some rarely occurring error samples.
Improved the Etcha.exe and the ucb1400 touch driver with a test mode for detection of damaged touch planes.
Improved the DIO configuration mechanism. It is now possible to set the signal level of the DIO output pins via a configuration file.
UserRegMon BugFix: The synchronization from registry to the xml file after deletion of a registry key could fail due a case sensitive comparison of the sub key.
|
| |
