|
Create a Simple Network Using Packet Tracer Topology Addressing Table Device Interface ip address Subnet Mask Default GatewayBog'liq Activity-1 - Create Simple Network Структура, Javob tcp IPPacket Tracer
– Create a Simple Network
© 2017 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
Page 6 of 14
Click on the Desktop tab at the top of the Laptop configuration window and select the PC Wireless icon.
Once the Wireless-N Notebook Adapter settings are visible, select the Connect tab. The wireless network
“HomeNetwork” should be visible in the list of wireless networks as shown in the figure.
Select the network, and click on the Connect tab found below the Site Information.
Step 3: Configure the PC
a. Configure the PC for the wired network
Click on the PC icon on the Packet Tracer Logical workspace and select the Desktop tab and then the IP
Configuration icon.
In the IP Configuration window, select the DCHP radio button as shown in the figure so that the PC will
use DCHP to receive an IPv4 address from the Wireless router. Close the IP Configuration window.
Packet Tracer
– Create a Simple Network
© 2017 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
Page 7 of 14
Click on the Command Prompt icon. Verify the PC has received an IPv4 address by issuing the ipconfig
/all command from the Command as shown in the figure. The PC should receive an IPv4 address in the
192.168.0.x range.
Step 4: Configure the Internet cloud
a. Install network modules if necessary
Click on the Internet Cloud icon on the Packet Tracer Logical workspace and then click on the Physical
tab. The cloud device will need two modules if they are not already installed. The PT-CLOUD-NM-1CX
which is for the cable modem service connection and the PT-CLOUD-NM-1CFE which is for a copper
Ethernet cable connection. If these modules are missing, power off the physical cloud devices by clicking
on the power button and drag each module to an empty module port on the device and then power the
device back on.
b. Identify the From and To Ports
|
|
Bosh sahifa
Aloqalar
Bosh sahifa
Create a Simple Network Using Packet Tracer Topology Addressing Table Device Interface ip address Subnet Mask Default Gateway
|
