|
Create a Simple Network Using Packet Tracer Topology Addressing Table Device Interface ip address Subnet Mask Default GatewayBog'liq Activity-1 - Create Simple Network Структура, Javob tcp IPPacket Tracer
– Create a Simple Network
© 2017 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
Page 4 of 14
The Interne cloud will need copper straight-through cable to connect to the Cisco.com server. Select the
copper straight-through cable in the Device-Selection box and attach it to the Ethernet interface of the
Internet cloud and the FastEthernet0 interface of the Cisco.com server.
Wireless_Router'>Part 2: Configure the Network Devices
Step 1: Configure the Wireless Router
a. Create the wireless network on the Wireless Router
Click on the Wireless Router icon on the Packet Tracer Logical workspace to open the device
configuration window.
In the Wireless Router configuration window click on the GUI tab to view configuration options for the
Wireless Router.
Next, click on the Wireless tab in the GUI to view the wireless settings. The only setting that needs to be
changed from the defaults is the Network Name (SSID)
. Here, type the name “HomeNetwork” as shown
in the figure.
b. Configure the Internet connection on the Wireless Router
Click on the Setup tab in the Wireless Router GUI.
In the DHCP Server settings verify that the Enabled button is selected and configure the static IP address
of the DNS server as 208.67.220.220 as shown in the figure.
c. Click on the Save Settings tab.
Packet Tracer
– Create a Simple Network
© 2017 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
Page 5 of 14
Step 2: Configure the Laptop
a. Configure the Laptop to access the wireless network
Click on the Laptop icon on the Packet Tracer Logical workspace and in the Laptop configuration
windows select the Physical tab.
In the Physical tab you will need to remove the Ethernet copper module and replace it with the Wireless
WPC300N module.
To do this, you first power the Laptop off by clicking the power button on the side of the laptop. Then
remove the currently installed Ethernet copper module by clicking on the module on the side of the laptop
and dragging it to the MODULES pane on the left of the Laptop window. Then install the Wireless
WPC300N module by clicking on it in the MODULES pane and dragging it to the empty module port on
the side of the laptop. Power the laptop back on by clicking on the Laptop power button again.
With the wireless module installed, the next task is to connect the laptop to the wireless network.
|
|
Bosh sahifa
Aloqalar
Bosh sahifa
Create a Simple Network Using Packet Tracer Topology Addressing Table Device Interface ip address Subnet Mask Default Gateway
|
