J
OURNAL OF
E
LECTRONIC
V
OLTAGE AND
A
PPLICATION
V
OL
.
2
N
O
.
1
(2021)
49-55
© Universiti Tun Hussein Onn Malaysia Publisher’s
Office
JEVA
Journal homepage:
http://publisher.uthm.edu.my/ojs/index.php/jeva
Journal of
Electronic
Voltage and
Application
e-ISSN : 2716-6074
*Corresponding author: kadir@uthm.edu.my
2021 UTHM Publisher. All rights reserved.
publisher.uthm.edu.my/ojs/index.php/jeva
49
Configure and Monitor the Networking using EIGRP
Protocol
Anis Zahirah Azman
1
, Abd Kadir Mahamad
1*
, Sharifah Saon
1
, Shipun Anuar
Hamzah
1
, Danial Md Noor
1
1
Faculty of Electrical and Electronic Engineering,
Universiti Tun Hussein Onn Malaysia, 86400, Parit Raja, MALAYSIA.
*Corresponding Author
DOI: https://doi.org/10.30880/jeva.2021.02.01.006
Received 06 February 2021; Accepted 18 May 2021; Available online 30 June 2021
1.
Introduction
Several protocols are used in the networking environment today, and routing protocols are among the most popular
routers. Their job is to ensure that routers have accurate remote network information to make correct packet forwarding
decisions to their destination. Routers and switches are involved in the network.
The router is a system that
communicates between two or more networks located in separate geographical locations,
that is knowledge to its
destination. When the packet enters the router, the packet's destination IP address is checked
and the entry on its
routing table. If the address is found in the routing table, the corresponding interface is placed as a packet. The switch is
a networking system for computers that links network segments. Routing is the method of transmitting data from
source to destination. It
consists of two types, static and dynamic routing [1].
Open Short Path First (OSPF), Routing Information Protocol (RIP), Intermediate System to Intermediate System
(IS-IS) and Enhanced Interior Gateway Routing Protocol (EIGRP), are the dynamic routing protocols that normaly
used in a network. There are benefits and drawbacks to of routing protocol. The determination and choice of routing
protocols depend on several parameters that affect the network efficiency. Most of
the routing protocols were
developed as open protocols, but some of them were produced as proprietary solutions. EIGRP,
created by Cisco
Systems, Inc., is an example of a proprietary routing protocol. Therefore, EIGRP was originally only available on
Cisco-produced computers [2]. In 2013, Cisco decided to release the basic EIGRP specification
as IETF Knowledge
RFC 7868, that allows the subsequent start of different open-source EIGRP implementations [3].
This paper's main target is to configure and monitor the network of the dynamic routing protocol. We will
configure the ping test as we want to check if the computer is connected to the network or not. Following with, check
