Packet Tracer
– Create a Simple Network
© 2019 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
Page
13
of
15
In the command prompt refresh the IP settings by issuing the
commands
ipconfig /release
and then
ipconfig /renew.
The output should show that the PC has an IP address in the 192.168.0.x range, a
subnet mask,
a default gateway, and DNS server address as shown in the figure.
b) Test connectivity to the Cisco.com server from the PC
From the
command prompt, issue the command
ping Cisco.com.
It may take
a few seconds for the ping
to return. Four replies should be received as shown in the figure.
Packet Tracer
– Create a Simple Network
© 2019 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
Page
14
of
15
Part 4: Save the File and Close Packet Tracer
Step 1: Save the File as a Packet Tracer Activity File (*.pkt)
To
save the completed network, click on
