Packet Tracer
– Create a Simple Network
© 2019 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
Page
7
of
15
Click on the Command Prompt icon. Verify that the PC has received an IPv4 address by issuing the
ipconfig /all
command from the command prompt as shown in the figure. The PC should receive an IPv4
address in the 192.168.0.x range.
Step 4: Configure the Internet cloud
a. Install network modules if necessary
Click on the
Internet Cloud
icon on the Packet Tracer
Logical
workspace and then click on the
Physical
tab. The cloud device will need two modules if they are not already installed. The PT-CLOUD-NM-1CX
which is for the cable modem service connection and the PT-CLOUD-NM-1CFE which is for a copper
Ethernet cable connection. If these
modules are missing, power off the physical cloud devices by clicking
on the power button and drag each module to an empty module port on the device and then power the
device back on.
b. Identify the
From and To Ports
Click on the
