init a adjust
Crystal
#iwpriv wlan0 mp_ctx background,stone
#iwpriv wlan0 mp_phypara xcap=26 //
to adjust Crystal and measure
#iwpriv wlan0 mp_phypara xcap=24 //
to adjust Crystal and measure
Crystal Calibration Success! Find Crystal Index = 24
iwpriv wlan0 efuse_set wmap,b9,18
CRYSTAL_CAL_STOP
#rtwpriv wlan0 mp_ctx stop
-------------------------------------------------------------------------------------------------------
6. Read Thermometer : iwpriv wlan0 mp_ther
-------------------------------------------------------------------------------------------------------
1. read Thermometer :
#iwpriv wlan0 mp_ther
return a value
2. write the HW thermal value to HW efuse
#iwpriv wlan0 mp_ther
write
3. use read Efuse CMD for verify the value from thermal offset.
#iwpriv wlan0 efuse_get rmap,(Efuse offset),1
-------------------------------------------------------------------------------------------------------
7. Enter To BT Test Link Mode : for combo IC (8723BS/BU)
-------------------------------------------------------------------------------------------------------
#ifconfig wlan0 up
//enable wlan interface
#iwpriv wlan0 mp_start
//enter mp mode
#iwpriv wlan0 mp_setbt dlfw
//Download BT path FW
#iwpriv wlan0 mp_setbt 2ant
//
if the efuse is empty, and use 2 antennas on the
Board.
#iwpriv wlan0 mp_setbt testmode,01
//01 => enter to BT 2.0 TestMode, 02 => BT4.0
Direct Test mode, 03 => Connect Test Mode,00
=> RF TxRx Test mode(non-link mode)
#iwpriv wlan0 mp_setbt setgen,01
// leave BT TestMode, Reset HCI
#iwpriv wlan0 mp_setbt down
//rollback to Wifi MP test.
