Reviziya tarixi: 01/01/2013 azpol yaxta laki uretan-alkid əsaslı parlaq lak Ünvan: Bakı şəhəri, Albalıq qəs. Sifariş üçün əlaqə nömrəsi

Download 307 Kb.
bet	2/5
Sana	02.03.2022
Hajmi	307 Kb.
	#678

1 2 3 4 5

AZPOL YACHT VARNISH
Alkyd Varnish
Address:
Albalilig settlement, Baku
Contact phones:
(+99412) 453 90 50
Fax: (+99412) 453 90 33
E-mail: office@nbgroup.az
www.nbgroup.az
PRODUCT DESCRIPTION:
A one pack alkyd varnish with high gloss and good durability.
INTENDED USES
For interior and exterior woodwork. For use at Newbuilding, Maintenance & Repair or On Board Maintenance.
PRODUCT INFORMATION
Colour Transparent
Gloss level High Gloss ( >90 %)
Solid content 52 ± 1% by volume, 56 ± 1% by weight
Typical Film Thickness 25-35 microns dry ( 48-38 microns wet)
Theoretical Coverage 19- 20 m²/litre at 25 microns dft, allow appropriate loss factors
Practical Coverage Allow appropriate loss factors
Method of Application Airless Spray, Brush, Roller
DRYING INFORMATION Overcoating Interval with
Temperature Touch Dry Hard Dry Minimum Maximum
10 °C 1 2 hours 36 hours 36 hours not limited
15 °C 8 hours 30 hours 30 hours not limited
25 °C 6 hours 24 hours 24 hours not limited
REGULATORY DATA
VOC 421 gr/l (UK-PG6/23(92))
Product Weight 0.91-093 kg/l
Flash point (Typical) 33 °C
Note: VOC values are typical and are provided for guidance purposes only. These may be subject to variation depending on factors such as differences in colour and normal manufacturing tolerances.
SURFACE PREPARATIONS
All surfaces to be coated should be clean, dry and free from contamination. High pressure fresh water wash or fresh water wash, as appropriate, and remove all oil or grease, soluble contaminants and other foreign matter in accordance with SSPC-SP1 solvent cleaning.
NEWBUILDING/MAJOR REFURBISHMENT
Ensure the wood is clean and dry prior to application. For new wood it is recommended that the first coat is thinned 4-5 % Azpol synthetic thinner for maximum penetration into the wood.
REPAIR/OBM
Ensure the wood is clean and dry prior to application. Azpol Yacht varnish may be applied directly over aged Azpol yacht varnish following thorough fresh water washing and degreasing provided the coating to be overcoated is in an intact and tightly adherent condition. Loose or flaking coatings should be removed back to a firm edge and Azpol yacht varnish or an appropriate primer should be used to repair the area before application of the full coat.
_APPLICATION

Download 307 Kb.

1 2 3 4 5

Download 307 Kb.