Windows ce 2 for the etop workstations User's Manual




Download 192,5 Kb.
bet22/23
Sana21.03.2017
Hajmi192,5 Kb.
#918
1   ...   15   16   17   18   19   20   21   22   23

7.2Connection via Ethernet


Note: Ethernet Connection is supported only by Microsoft Activesync V3.x.
If the UniOP workstation has an on-board Ethernet port or is equipped with the TCM10 Ethernet module, the connection with Active Sync can be established also via Ethernet.
Ethernet connection requires that a partnership with the CE device be established.

If not established, please refer to the previous chapter; connect to the device via serial line and setup a partnership.

Once the partnership is established, the serial link must be terminated. This can be done directly from the CE unit with a double click on the connection icon shown in the system icon tray. On the “Connection Status” dialog box, click then on “Disconnect”.
In Microsoft ActiveSync select “File\Connection Settings” and verify that network connection is allowed, like shown in the following picture:

Figure 2


Close the “Connection Settings” dialog and run on the panel the “Active Sync” program available from “Start\Programs\Communication”.

In the “ActiveSync” dialog box select the method of connection as “”Network Connection” and set the “Connect to:” according with the personal computer name from where ActiveSync is started. This parameter should be automatically proposed by the system and it will match with the identification name given to the PC on the Microsoft Network.

Click then “Connect” to activate the connection.

A message will confirm that the connection has been established successfully.



  1. System Start-up Diagnostic Information and troubleshooting


Download 192,5 Kb.
1   ...   15   16   17   18   19   20   21   22   23




Download 192,5 Kb.

Bosh sahifa
Aloqalar

    Bosh sahifa



Windows ce 2 for the etop workstations User's Manual

Download 192,5 Kb.