|
Usb-serial Adapter User Guide Product Features
|
bet | 1/2 | Sana | 24.06.2020 | Hajmi | 261,5 Kb. | | #10606 |
USB-Serial Adapter
User Guide
1. Product Features
2. System Requirements
3. Driver Installation (WIN2000)
4. Changes COM Port
5. Setting Up the RS232 Serial Device
6. Uninstalling the Driver Program
Product Features
USB Specification Rev. 1.1 compliant
Support the RS232 Serial interface
Over 1Mbps data transfer rate
Support remote wake-up and power management
System Requirements
IBM PC 486DX4-100 MHz CPU or higher or compatible system
Available USB port
CD-ROM drive
Windows 2000
Driver Installation (WIN2000)
Follow the steps below to install Window 2000 driver of USB-Serial cable:
Power on your computer and make sure that the USB port is enabled and working properly.
Plug in the USB-Serial cable into the USB port and run the Found New Hardware Wizard to assist you in setting up the new device. Click Next to continue.
Insert the USB-Serial cable software driver into the CD-ROM drive and click Next to continue. For Windows 98, click Search for a suitable driver for my device(recommand) and click to search driver from the CD-ROM drive
Windows will detect the driver and Click Next to continue installation.
Click Finish to continue and let Windows copy the needed files to your hard disk.
You can to check the Device Manager and see the Prolific USB to Serial Comm Port)
.
Changes COM Port
Under Windows 98SE , you can change the COM Port via
|
| |